+1-415-467-3400

Thickener

9 Item(s)

per page

Set Descending Direction
  1. Tank, 1,100 Gallon, S/st, 56" X 98", FT/CB,

    Stock Number: S740831

    Wastewater recuperation/thickener tank, approximately 1,100 gallon capacity, 304 stainless steel construction. Tank measures 56" diameter X 98" straight side with 57" long cone bottom leading to 3-1/2" discharge with manual gate valve. Includes 17" X 12" manway along with 6" side opening. Unit has three (3) 10" X 4" sight glasses. Tank has 3/16" shell thickness. Very good condition.
  2. Tank, 1,100 Gallon, S/st, 56" X 98", FT/CB,

    Tank, 4,400 Gallon, S/st, 99" X 98", FT/CB,

    Stock Number: S740834

    Wastewater recuperation tank, approximately 4,400 gallon capacity, 304 stainless steel construction. Last used as thickening/clarifying tank. Tank measures 99" diameter X 98" straight side with 76" long cone bottom leading to 3" diameter discharge. Includes 24" diameter manway. Unit has two (2) 3" diameter side ports. Tank has 3/16" shell thickness. Unit includes 15" center inlet tube measuring 9'3" long. Very good condition.
  3. Tank, 4,400 Gallon, S/st, 99" X 98", FT/CB,

    Tank, 5,400 Gallon, S/st, Agit, 92" X 128", FT/CB,

    Stock Number: S740835

    Stainless steel wastewater recuperation tank, approximately 5,400 gallon capacity. Last used as a thickening/clarifying tank. Tank measures 92" diameter X 128" straight side with 77" long cone bottom leading to 3" diameter discharge. Includes 24" manway. Unit has two (2) 3" diameter side ports. Tank has 3/16" shell thickness. Includes chain sweep agitator designed to scrape chains along interior of cone. Agitator driven by 1 HP, 230/460V motor through SEW gearbox. Very good condition.
  4. Tank, 5,400 Gallon, S/st, Agit, 92" X 128", FT/CB,

    Thickener, 35' Dia, Eimco, Bridge,

    Stock Number: S708251

    Eimco 35' diameter , type BX thickener mechanism, S.O.# 3003-a, previously used on 5'10" side wall depth tank, bridge supported rake mechanism and W-60,. 26 RPM drive, 30,000 ft. Lbs. Torque. Unit has 24" semi-automatice motorized lifting device with ge 1 HP, model 5K213BG8303, 365 RPM lift motor, bridge and drive look good; tank not available. Requires 3 HP 1800 RPM drive motor, frame 213, not included.
  5. Thickener, 35' Dia, Eimco, Bridge,

    Thickener, 80' Dia, Eimco, Type-B, Complete System

    Stock Number: S734199

    Thickener, Eimco type B, 80' diameter tank, approximately 500,000 gallon. Rake type B-40 with 24" lift, 75,000' ft-lb drive, rake motor 3 HP, 230-460 volt, lift motor 1 1/2 HP, designed for use at -40 deg. F., tank and top cover are heat traced and insulated. Surge water feed tank available. Less bottom rakes & shaft. Excellent condition.
  6. Thickener, 80' Dia, Eimco, Type-B, Complete System

    Thickener, 90' Dia, Dorr-Oliver, Mechanism Only,

    Stock Number: S708000

    Thickener, Dorr-Oliver mechanism, previously used on 90' diameter x 12' deep thickener. Mechanism has 2 HP motor & V-belt drive. Serial number 59085-1.
  7. Thickener, 90' Dia, Dorr-Oliver, Mechanism Only,

    Thickener, Lamella, 240 SF, 45 Deg, C/st, 160 GPM,

    Stock Number: Z708400

    Thickener/gravity settler, Lamella, Model 240/45 with 240 square feet of settling area, agitated flocculant tank, and 45 degree angled thickening plates. It measures 6' across x 13' high. Flow rate is approximately 160 GPM. Equivalent in capacity to a 16' diameter conventional thickener. Manufactured by Parkson.
  8. Thickener, Lamella, 240 SF, 45 Deg, C/st, 160 GPM,

    Thickener, Lamella, 30 GPM, Reconditioned, Clarifier,

    Stock Number: A738113

    Clarifier, rated for 30 GPM, includes Lamella Honeycomb style plate media, (2) 90 gallon floc tanks, unit has been reconditioned and usnused since. Inside and outside were stripped and sanded, inside had coal tar applied, outside was epoxy painted and plate packs were removed and repaired, as needed. Clarifier has been tested.
  9. Thickener, Lamella, 30 GPM, Reconditioned, Clarifier,

    Thickener, Lamella, LGST Series 55, Tank, Inclined Plates,

    $0.00

    Stock Number: S740491

    Lamella thickener/gravity settler, appears to be LGST Series 55. Unit consists of (13) stainless steel plates, measuring 98" long x 72" wide. Complete with flocculation tank with 30" x 20" paddle agitator, driven by ½ HP, 115/230-208V, 1725 RPM, 1-phase motor thru 92.82:1 ratio gear reducer. Also includes flash mix tank measuring 24" x 24" x 36" deep, with Lightnin agitator, driven by 5 HP motor thru 7.24:1 ratio gear reducer. Inlet measures 35" X 35" and discharge is 9" flange, tapering to 4" outlet. Good condition.

9 Item(s)

per page

Set Descending Direction

Please wait...